i30N pre cut easy fit sunstrip with free essential squeegee

Available in Matt or gloss black in a range of designs and colours. 

PLEASE NOTE: There is a cutout for the rain sensor for the auto wipers, This is correctly positioned for the Hatchback, but may be incorrect for the Fastback, it’s also made for PFL model, and will fit FL model but I’m not sure about the sensor cutout position  

(I'm awaiting confirmation)

For fitting advice, watch my video. It’s really easy, if you do it right and make sure it’s properly dry, especially when it’s cold outside. 

All you need is a spray bottle of soapy water and a squeegee. (The squeegee is included with your sunstrip, the soapy water, you’ll have to find yourself)

Watch the video here 

Sunstrip fitting instructions:

You will need a squeegee (included) and a spray bottle with water and a dab of dish washing liquid mixed into the water.

1. Spray the screen and bonnet with the water mix, make thoroughly wet.
2. Carefully peel the sunstrip off the backing sheet and place adhesive side up on the wet bonnet. The water will help stop it falling off the bonnet.
3. Spray the adhesive side of the sunstrip with the soapy water mix, wet thoroughly.
4. Wet the top of the screen again.
5. Carefully place the sunstrip in position on the screen, you’ll be able to slide it into position.
6. Using the felt edge of the supplied squeegee, carefully squeeze out all of the water.
7. Dry off with a micro fibre or towel and check for visible water or air bubbles, squeegee them out as required.
8. MOST IMPORTANT – leave to dry thoroughly, as long as possible.

This will be much longer in cold conditions.

You can go over the sunstrip with a hair dryer or heat gun to speed up the drying process.

DO NOT use wipers for at least 24 hours.

Enjoy your new look.