NEW! i30N pre cut easy fit sunstrip, printed logo Black on black, with free essential squeegee

Only available in matt black, with a printed Black logo.

A more affordable, but still high quality sunstrip, cost saved by printing the logo, rather than applying in separate vinyl.

These are the same quality vinyl as our other sunstrips, but are limited in available colours (only black on matt black).

The logo being printed, has no effect on the thickness, therefore actually makes application to the cars screen a bit easier.

These are in our popular black on black look and at a price that doesnt break the bank.

Graphics show the logos in white, only so you can clearly see the size and style of the logo, all logos will be black on a matt black sunstrip

PLEASE NOTE: There is a cutout for the rain sensor for the auto wipers, This is correctly positioned for the Hatchback, but may be incorrect for the Fastback, it’s also made for PFL model, and will fit FL model but I’m not sure about the sensor cutout position  

(I'm awaiting confirmation)

For fitting advice, watch my video. It’s really easy, if you do it right and make sure it’s properly dry, especially when it’s cold outside. 

All you need is a spray bottle of soapy water and a squeegee. (The squeegee is included with your sunstrip, the soapy water, you’ll have to find yourself)

Watch the video here 

Sunstrip fitting instructions:

You will need a squeegee (included) and a spray bottle with water and a dab of dish washing liquid mixed into the water.

1. Spray the screen and bonnet with the water mix, make thoroughly wet.
2. Carefully peel the sunstrip off the backing sheet and place adhesive side up on the wet bonnet. The water will help stop it falling off the bonnet.
3. Spray the adhesive side of the sunstrip with the soapy water mix, wet thoroughly.
4. Wet the top of the screen again.
5. Carefully place the sunstrip in position on the screen, you’ll be able to slide it into position.
6. Using the felt edge of the supplied squeegee, carefully squeeze out all of the water.
7. Dry off with a micro fibre or towel and check for visible water or air bubbles, squeegee them out as required.
8. MOST IMPORTANT – leave to dry thoroughly, as long as possible.

This will be much longer in cold conditions.

You can go over the sunstrip with a hair dryer or heat gun to speed up the drying process.

DO NOT use wipers for at least 24 hours.

Enjoy your new look.